Categories

Carbon fibre sleeve 18x750mm

Carbon fibre sleeve 18x750mm

More details

T4-0146

Availability: This product is no longer in stock

7,62€

Add to cart

Add to wishlist

30 other products in the same category:

Previous
Next

Fibre: Torayca T300J 400 tex (6k).

Diameter: 4-22 mm,
Thickness: 0.35 mm,
Lenght: 750mm,

Technical data at 45° braid angle:

Diameter: 17.8 mm,
Width flat: 28.0 mm, 
Weight: 18.1 g/m.

Application:

Torsion-proof pipes of various diameters. Orthopaedic engineering (prosthesis), sport equipment construction. The sleeve diameter can be varied by clenching or stretching. Delivered in stretched condition. Processing: Use plenty of R&G release spray on core material (slide coating) and allow to dry. Pass sleeve over material and pull both ends for proper fit – fit under tension if necessary. Apply resin with a brush. The area to be processed can be warmed using a hairdryer if required. This will liquify the resin and impregnate the fibre quickly and safely. (Do not forget resin fumes – ensure that the room is well aired or wear a protective mask.) The core is gripped following hardening and the pipe removed. Small size components may be pre-frozen. In this way it is easier to remove the shrunken metal core. Please note: For technical reasons it is not possible to wind up sleeves in a fibre angle of 45°. The amounts of differ therefore on the length at 45°.

Attention, this product is sold on 0,75m!!

 

Basket  

No products

0,00€ Shipping
0,00€ Tax
0,00€ Total

Prices are tax included

Check out

Newsletter

PayPal

TESt"; ?>