Categories

Mark Fit Strong

Decal Setting Solution Mark Fit Strong

More details

T1-0195

30 other products in the same category:

Previous
Next

Mark Fit is a special solvent designed to soften your model decals which will allow you to apply them onto difficult to apply areas such as bumpy and curved surfaces. This “strong” version has a more powerful formula for softening decals compared to the standard version. The Strong version help decals adhere and conform to difficult curved surfaces or matte-painted surfaces. In addition, it could also help speed up the decal application process. The Bottle cap comes with brush applicator and contains 40ml of solvent.

Note: May cause damage to painted surface in some cases, particularly surfaces painted with acrylic paints.

How to Use:

  1. Apply Mark Fit solvent to area where decal is to be positioned.
  2. Place decal onto the area.
  3. Slide decal into correct position by a wet finger.
  4. Use a soft cloth or cotton swab to remove excess water and any air bubbles.
  5. Apply Mark Fit over the decal again, and then use a soft cloth or cotton swab to conform it to the model's surface.
  6. Do not touch until decal dries completely.

Weight: 40ml 

Basket  

No products

0,00€ Shipping
0,00€ Tax
0,00€ Total

Prices are tax included

Check out

Newsletter

PayPal

TESt"; ?>