Categories

HW-01 Stepper Motor Drive Controller L298N

HW-01 Stepper Motor Drive Controller Board Module L298N

More details

A2-0233

30 other products in the same category:

Previous
Next

HW-01 Stepper Motor Drive Controller Board Module L298N.

Basic Attributes

Name

Double H Bridge Motor Driver Module

Working mode

Drived by H bridge

(double lines)

Control chip

L298N ( ST )

Logical voltage

5V

Driving voltage

5V — 35V

Logical current

0mA-36mA

Driving current

2A (MAX single bridge)

Storage temperature

( -20 ℃)—( +135 ℃)

Maximum power

25W

weight

30g

Periphery dimension

43*43*27mm

 

Product features:

1.Using L298N made by ST company as the control chip,the module has such characteristics as strong driving

ability,low calorific value and strong anti-interference ability.

2.This module can use built-in 78M05 for electric work via a driving power supply part.But to avoid the damage

of the voltage stabilizing chip,please use an external 5V logic supply when using more than 12V driving voltage.

3.Using large capacity filter capacitor,this module can follow current to protect diodes,and improve the

reliability

L298N is a kind of high voltage,high current motor driver chip produced by ST company.Having 15 pins as package, 
this chip has such features as high working voltage(maximum voltage up to 46V),large output current(instantaneous 
peak current up to 3A,continuous working current 2A) and 25W of rated power.Two built-in H birdge high voltage and 
large current full bridge drivers can be used to drive the DC motor and stepper motor,relay coil and so on.Using standard 
logic level signal control,it has two enable control ends.It permits or prohibites device having a logic power supply imput 
without the impact of input signal,which enables the internal logic circuit part works at low voltage.The chip can connects 
to external detecting resistor to give the variations to the control circuit.Using L298N chip to drive the motor,this chip can 
drive a stepping motor or four phase stepping motor,and two DC motors as well.

Port function:

 

This module is integrated with a built-in 5V power.When the drive voltage is 7V-35V, 
it can enable the onboard 5V logic power supply;afterthe power supply,don't input 
voltage in the interface+5V power supply,but you can lead the 5V for external use. 
when ENA enable IN1 IN2 control OUT1 OUT2 
when ENB enable IN3 IN4 control OUT3 OUT4

 

Applied cases: 
1 Driving stepper motor 
The connection of driving a common 4 line 2 phase electric motor is shown in below figure 
after enable ENA ENB 
Input the following driving timing from IN1-IN4,then the speed and direction of the stepper 
motor can be controlled

 


2 Driving DC motor 

Because the module is drived by double H bridge,it can drive two motors simultaneously. 
The connecting method is shown inbelow figure 
after enable ENA ENB 
You can imput the speed and direction of PWM signal drive motor 1 from IN1 IN2 
You can imput the speed and direction of PWM signal drive motor 2 from IN1 IN2 
The signal is shown in the figure

Basket  

No products

0,00€ Shipping
0,00€ Tax
0,00€ Total

Prices are tax included

Check out

Newsletter

PayPal

TESt"; ?>