Maximize 
TinkerKit PushButton
TinkerKit PushButton
Categories
- Services
- Gift Coupons
- Kites
- Rockets
- Robots
- Arduino
- Cars
- Multicopters, drones
- Planes
- Helicopters
- Boats
- Display models
- 1/100 ir 1/144 Modeliai surenkami be klijų
- 1:12, 1:20, 1:24 models
- 1:32 lėktuvai, sraigtasparniai ik kiti
- 1/35 miniatures
- 1/35 military
- 1:48 models
- 1:72 Žmonių figūrėlės
- 1/72 planes and hellis
- 1:72 scale vehicles
- 1/350 & 1/700 ships
- 1:100 antžeminė karinė technika
- 1:144 planes
- Wooden planes
- Wooden ships
- Paper models
- Plan,scheme
- Wooden ship parts
- Accessories
- Other models
- Batteries
- Chargers
- Receivers
- Transmitters
- Speed controllers
- Servo
- Engines
- Electronics
- Accessories
- Building materials
- Tools
Maximize 30 other products in the same category:
TinkerKit PushButton.
The Pushbutton Module is possibly the simplest sensor available. It detects when a person or an object presses on its circular cap.
Module Description:
This module features a 12mm pushbutton , the standard TinkerKit 3pin connector, a green LED that signals that the module is correctly powered and a yellow LED that is lit only when the button is pressed.
This module is a SENSOR. The connector is an OUTPUT which must be connected to one of the INPUT connectors on the TinkerKit Shield.
Code Example:
/*
Button
Turns on and off a T010111 LED Module connected to O0 (digital
pin 11), when pressing a T000180 pushbutton attached to I0 (analog pin 0).
created 2005
by DojoDave
modified 17 Jun 2009
by Tom Igoe
modified 7 dec 2010
by Davide Gomba
This example code is in the public domain.
based on http://www.arduino.cc/en/Tutorial/Button
*/
#define O0 11
#define O1 10
#define O2 9
#define O3 6
#define O4 5
#define O5 3
#define I0 A0
#define I1 A1
#define I2 A2
#define I3 A3
#define I4 A4
#define I5 A5
// constants won't change. They're used here to
// set pin numbers:
const int buttonPin = I0; // the number of the pushbutton pin
const int ledPin = O0; // the number of the LED pin
// variables will change:
int buttonState = 0; // variable for reading the pushbutton status
void setup() {
// initialize the LED pin as an output:
pinMode(ledPin, OUTPUT);
// initialize the pushbutton pin as an input:
pinMode(buttonPin, INPUT);
}
void loop(){
// read the state of the pushbutton value:
buttonState = digitalRead(buttonPin);
// check if the pushbutton is pressed.
// if it is, the buttonState is HIGH:
if (buttonState == HIGH) {
// turn LED on:
digitalWrite(ledPin, HIGH);
}
else {
// turn LED off:
digitalWrite(ledPin, LOW);
}
}
product (empty)
-
- -15% 30,99€ 26,34€
Viewed products
